VU Meter Arduino

// Led VU Meter Example
// Version 1.0
// Written by James Newbould

int led[10] = { 4, 5, 6, 7, 8, 9, 10, 11, 12, 13 }; // Assign the pins for the leds
int leftChannel = 0;  // left channel input
int left, i;

void setup()
{
for (i = 0; i < 10; i++)  // Tell the arduino that the leds are digital outputs
  pinMode(led[i], OUTPUT);
//  Serial.begin(9600); // Uncomment to enable troubleshooting over serial.
}

void loop()
{
left = analogRead(leftChannel);  // read the left channel
// Serial.println(left);  // uncomment to check the raw input.
left = left / 1;    // adjusts the sensitivity  
//  Serial.println(left);  // uncomment to check the modified input.
// left = 1500;  // uncomment to test all leds light.
// left = 0;    // uncomment to check the leds are not lit when the input is 0.

  if (left == 0)  // if the volume is 0 then turn off all leds
   {
   for(i = 0; i < 10; i++)
     {
     digitalWrite(led[i], LOW);
     }
  }
  
  else
  {
   for (i = 0; i < left; i++) // turn on the leds up to the volume level
    {
     digitalWrite(led[i], HIGH);
    }
    
    for(i = i; i < 10; i++)  // turn off the leds above the voltage level
     {
      digitalWrite(led[i], LOW);
     }
  }
}